Next: Waterfall Target
Previous: 5.3.2.8 Cooling
- 1. At the C:/prompt in DOS type "win" to start windows.
- 2. Open the IQ Master 2.10 Program Group by double clicking on it.
- 3. Start the IQ Master program by double clicking on it.
Vertical positioning
- 1. From the Communications menu select axis.
- 2. Type 1 in input box. Then click ok.
- 3. From the Communications menu select terminal.
- 4. Type "run" (enter).
- 5. Follow the on screen instructions.
- a. Home the target ladder assembly if necessary.
- b. Type "G1=(position in inches)" to change position.
- c. Type "G2=(speed in in./min.)" to change speed. (NOT
ADVISED)
- d. Type POS1 to display current position.
- 6. When finshed positioning, type "x" (enter).
- 7. Close terminal window.
- 1. Go to negative (-) values.
- 2. Go beyond 25 inches.
Rotational Positioning
- 1. From the Communications menu select axis.
- 2. Type 2 in input box. Then click ok.
- 3. From the Communications menu select terminal.
- 4. Type "run" (enter).
- 5. Follow the on screen instructions.
- a. Home the target ladder assembly if necessary.
- b. Type "G1=(angle in inches)" to change angle.
- c. Type "G2=(speed in in./min.)" to change speed. (NOT ADVISED)
- d. Type G6 to display current position.
- 6. When finshed positioning, type "x" (enter).
- 7. Close terminal window.
- 1. Go to negative (-) values.
- 2. Go beyond 355(degrees)
Next: Waterfall Target
Previous: 5.3.2.8 Cooling
10/13/1997