****************************************************
The following has been updated 2013/1/24
****************************************************


**************************
General:
**************************

- From KP and DW: Need PID corrections for all resonances. -> apply to AsymResults.xls to get the corrected reosnance asymmetries -> Table 15 and 16.

- From DW: Will help a lot if can summarize all PID corrections, run-by-run values, for all DIS and RES kinematics. -> XZ double check all values in AsymResults.xls

**************************
For the resonance paper
**************************

From DW: Need all run-by-run deadtime corrections for RES: missing RES#7b and all uncertainties. Make sure to include both narrow and wide.

***Question: Do we need Kai's analytic results for the OR deadtime???

From XZ: Need to complete SOM and update the analysis results of the paper throughout. <- ongoing 

From XZ: Need to contact J. Erler for C1,2 values at RES kinematics (?).

Numbers in the resonance paper but not SOM: DIS formula values for Ares. <- Probably from Diancheng's report???

**************************
For the SOM
**************************

----------------------
in Section 3.5, KP/som_bpmcalib.tex
----------------------

From KP: Need bull's eye calibration

----------------------
in Section 3.6, KP/som_optics.tex
----------------------
From KP: need vertex calibration plot for Left DIS#1(Fig.11); -> Then update Table 7.

----------------------
in Section 3.8, XZ/som_allbg.tex
----------------------

XZ/DW: double check AT on the right HRS was done at Q2=1.907 (Table 14);

RM/XZ: Need to use duality for the Al endcap evaluation, so the point that our measured RES asymmetries agree with DIS formula within their stat uncertainties must be made somewhere prior.

----------------------
in Section 3.9, DW/som_radcor.tex
----------------------
From DW: What is the form factor used in the e-p and e-n elastic (part of the quasi-elastic) asymmetry evaluation (line 847-851)? - These are from the HAPPEX code, need to check references!
 -- update 2013/01/29, using "Sec VII in Phys. Rev. C 69, 065501 (2004)"

From DW: Need radiative corrections for resonances -> Table 16. Update 2013/Jan: preliminary numbers are available but need fine interpolation to extract A(<Q2>,<W>) from theory tables. Also missing uncertainties.

Table 15: Applied all preliminary corrections here (note: RC needs to be updated, see above). Need to re-evaluate error of fRC in Table 16 (DIS should shrink).  

RC for resonances: How to evaluate error? Note that if table is good to 20%, it would cancel in the RC ratio since A(<Q2>,<W>) is now from table not DIS. 

--------------------------------------------------------
Resonance questions: 
-----------------------------------------------------

Now RES#3 is 3 sigma away! 

1) check if A(<Q2>,<W>) from the table is consistent with the values theorists just sent us.

Answer: from asym.ps from Lee (see log 2013/1/10), the value of A at W=1.263 is about -94ppm, agree with DW's number. 

2) The large value of RC for RES3 is not only due to being close to QE, but also the APV structure near Delta: If APV is peaked at 1.232 and drops off when it's away from 1.232, then it would appear as if fRC is large, since our average <W> is right on the peak.