• Main INDEX
  • Monthly INDEX
  • PREV
  • NEXT
    Make New Entry, Make Followup Entry

    User name A. Camsonne

    Log entry time 15:12:48 on February26,2009

    Entry number 263503

    This entry is a followup to: 263500

    keyword=Test Compton Edet plan A

    Good news my decoding works for plan A.
    Bad news ... plan A is very non uniform and there are holes, we miss the last 3 strips of each group of 16.
    Since this is done with the calibration signal, most likely it is not the detector. I will check the front end discriminator boards. For the holes, might be a mistake in the logic ( could be fixed by upgrading the firmware ) or routing problem or problem at the trigger.
    Most likely easy to fix in the spare board being made.
    In Y axis strip number in X axis event number in the run 16068

    FIGURE 1