Log entry time 21:24:43 on February 05, 2011

Entry number 346087

This entry is a followup to: 346071

Now that the BigBite EDTM module is acting as the master module, I have 
sent a copy of the back output signal to the left and right HRS's.  With
David's help we measured the delay between the back and front output's on
each module in both HRS's.  This delay turns out to be about 120 ns for 
all four modules.  

On each HRS, I used a fan-out to produce two copies to go into the back 
input for the S1 and S2 EDTM.  I verified that both were working.  On the
left HRS, I then used a front output on the S2 EDTM to generate the 
pulser for the S2m Amp module, which sends the signal to splitter box on 
S2m and eventually to the discriminator for each channel.

Unfortunately, I do not have a S2m Amp module for the R-HRS, but I would 
like to try a PS 776 10x amplifier to see if that will work.

Tomorrow, I will try to set the relative delays for the modules to
produce a S1/S2m coincidence on each arm to mimic the singles triggers.