Make New Entry, Make Followup Entry
User name A. Camsonne
Log entry time 15:12:48 on February26,2009
Entry number 263503
This entry is a followup to: 263500
keyword=Test Compton Edet plan AGood news my decoding works for plan A.
Bad news ... plan A is very non uniform and there are holes, we miss the last 3 strips of each group of 16.
Since this is done with the calibration signal, most likely it is not the detector. I will check the front end discriminator boards. For the holes, might be a mistake in the logic ( could be fixed by upgrading the firmware ) or routing problem or problem at the trigger.
Most likely easy to fix in the spare board being made.
In Y axis strip number in X axis event number in the run 16068
FIGURE 1
