Fig. 3 shows the mirror cuts that I used. It is interesting that mirror 13 shows what looks like two dense regions(Fig 4). I first though that maybe the cuts for that mirror were bad, so I applied the same cuts to an older run that I had already looked at (1851) which you can see in Fig 5. And there seems to only be one spot there, so not the cuts. Then I realized that 2024 was a different kinematic run than the other two runs, so maybe that was the reason. So I replotted the using only one set of the runs each time and I still see the double image on mirror 13.
Figure 6 shows the ADC's with mirror cuts and some shower cuts. The red
curve is the adc with a mirror cut corresponding to that pmt, and the
blue curve is the adc of the pmt with a mirror cut from a far away
mirror. Finally, fig 7 shows the adc vs tdc.
A copy of this log entry has been emailed to: brads,meziani,flay,yqiang,xqian
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6