I tweaked the attenuation and offset to get in the range of the 1881 of ROC3 ( only 12 bit ), after I played with the gate of ROC4 to have a good range. I was trying to optimize the range for the V792, but at some point the signals did not make sense. I think we might need to add the overflow bit in our decoding so I reduced the attenuation and offset, it seems the signal is around channel 700. The signal fastbus are correlated with each other and the VME signal are too. Though I did not see a good correlation fastbus and VME, I mixed the channel of ROC4,ROC4, ROC17,ROC14, so that one VME pairs with one fastbus, it did not improve. I think I will have to tweak the timing since the V792 is triggered by the L1A, so I think it should be cleaner when I trigger them with the retimng signal I will tweak the amplitude to reduce the which is still long right now on the VME ADCs