Make New Entry, Make Followup Entry
User name A. Camsonne
Log entry time 02:38:48 on December16,2010
Entry number 344628
This entry is a followup to: 344620
keyword=Test config BenL1testI made a copy of the TrigDVCSBen config called BenL1test.
This is the same but with EB1 and ER1 running on adaql1.
Writing directly to the local disk of adaql1 seems to help a bit compared to writing through NFS.
I will check the data most likely it will be good if that is the case we will run a bit like that and switch back to adaql2 when it is less full.
The procedure to switch computer is a bit complicated so I guess Bob, Carlos or I should do it.
First to a kcoda on the computer running the current DAQ
Do a killall telnet to close all the telnet window.
Log on the computer you want to run the DAQ.
If it is adaql2 do a startcoda, if adaql1 type startcodal1
Then on the runcontrol panel hit the connect and after config button.
If you are on adaql2 choose the TrigDVCSBen config if on adaql1 choose the BenL1test config.
FIGURE 1
