The RQ1 power supply had been dumped. Both Q1s dumped when the RD1 dumped. The LQ3 helium level was red on the display, but the LQ3 had not dumped yet. I ramped the current down. At some point the LQ3 supply also tripped off. After the magnets had been re-filled I reset the Q1s and turned the software regulators on. LQ3 was reset without incident. At some point I noticed the GUI for the RQ1 was showing a temperature fault. Looking at the control board I did not see any red LEDs, only the usual green ones. I decided to ramp the supply down and cycle power to reset the control board. While it was ramping down the fault on the GUI went away. I tried to catch the supply at the current it was at, but added one too many zeros to the set current. The supply did not like that and turned off in angry protest. After the RQ1 had re-filled with helium we cycled power on the Danfysik, started the supply, and turned on the software regulator.