Analysis Summary/ Run List for Day shift
Run 3100 -- 20cm He4 target, 4 muA. Right quadrupole 2 tripped during this run! Someone should look at the data to see where this happened. Both replays were done.
Run 3101 -- 20cm He4 target, 4 muA. This is a junk run that was done while the quad was being reset. I replayed the full run anyway, but the analyzer had a segmentation violation at the end of the run. I did it again and it replayed all right.
Run 3102 -- 20cm He4 target, 4 muA. We stopped this run early to cycle right quadrupole 2. The 40,000 replay looked fine to me, but the run ought to be checked out.
Run 3103 -- 20cm He4 target, 4 muA. Run stopped a little early due to no beam. Replay looked fine.
--------> Changed to 15 cm Al dummy target!
Run 3104 -- Cosmics run with no beam (since MCC is working on it), 15 cm Al dummy target is in.
Run 3105 -- 15 cm aluminum dummy target, beam current 5 muA, Spot plots for run 3105 in halog 353478. To get the T3 rate up to what we had before (about 125 Hz), we raised the beam current to 6 muA. Plane 5 right bar3 (N5-3R) tripped off in the first part of this run (found it by looking at the replay histograms). Stopped the run and started a new one after resetting the trip!
Run 3106 -- 15 cm aluminum dummy target, beam current 6 muA, Plane 5 right bar3 (N5-3R) tripped off again in this run and was reset!!
--------> Changed to 20 cm He4 target!
Run 3107 -- 20cm He4 target, 4 muA. Plane 5 right bar3 (N5-3R) tripped off again in this run and was reset! Three times in 15 minutes! Histogram N5 Plane Right Raw TDC 2 looks weird in the 40k event replay, so I logged it.
Run 3108 -- 20cm He4 target, 4 muA. Replay looks fine.
Run 3109 -- 20cm He4 target, 4 muA. Replay looks fine.
Run 3110 -- 20cm He4 target, 4 muA, in progress