I ramped down the LQ1 and cycled power on the Danfysik power supply. I tried to ramp down the RQ1, but the supply did not respond. I went down to try the local controls, but it did not respond to that either. The local display also had a random @ symbol on it, indicating it had seen a good amount of background radiation. All of this has been seen before. The magnet was at about 2000A. I wanted to avoid having to dump the magnet. I got some minigrabber leads and tied some of the lines on the P1 connector, of the Regulation Module, to ground. Apparently the higher order bits are toward the top of the board, starting at pin 29 and working down from there. This worked and still allowed the ramp module to control the ramp down rate. I got the supply down to about 25A and then hit the big red button. I turned the supply back on and everything came back up ok.