Subject:
Re: Error codes on a SC40 Airtek dryer
From:
Jack.Mahoney@parker.com
Date:
Mon, 15 Oct 2007 15:58:51 -0400
To:
segal@jlab.org


Jack:

Diagnostic codes are as follows:

E1 - Break in Dew Point Circuit (from air temp probe in evaporator to control panel)
E2 - Short in Dew Point Circuit
E3 - Low refrigerant level shutdown
E4 - Low Dew Point Shutdown
E5 - High Dew Point Shutdown
E6 - Low refrigerant pressure Shutdown
E7 - High refrigerant pressure Shutdown

For further service information contact the Airtek service separtment at 800-451-6023.  There can be several reasons for the E5 you are getting.  The most common causes are high inlet air temperature to the unit, high ambient temperature (over 100 degrees), excessive inlet flow iin SCFM, and inlet pressure to the inlet of the dryer.

Jack Mahoney
Director of Training
Airtek Division of Parker Hannifin
Phone: 716-289-3102


segal@jlab.org

10/15/2007 11:27 AM
	
To
	jack.mahoney@parker.com
cc
	
Subject
	Error codes on a SC40 Airtek dryer

	




   I have an Airtek model SC40 dryer, serial number 99-10275H.
It is occasionally giving me an E5 error code on the display.
What does this mean?  I do not seem to have any documentation
for this dryer, is there some information I can get on it?
Maybe at least a list of error codes?
  Thanks in advance for any assistance you can provide.
-- 
John(Jack) Segal
Hall A Instrumentation, Controls and
Detectors Coordinator
Thomas Jefferson National Accelerator Facility
Suite 12
12000 Jefferson Avenue
Newport News, VA 23606-4323
Phone: (757) 269-7242


"PLEASE NOTE: The preceding information may be confidential or privileged. It only should be used or disseminated for the purpose of conducting business with Parker. If you are not an intended recipient, please notify the sender by replying to this message and then delete the information from your system. Thank you for your cooperation."