EtherLite Setup: Windows NT 4.0

<H3> EtherLite Setup:<br> Windows NT</H3> <h4>Introduction</h4> <ul> <li><a href="xxxx-about-this-guide.html">About This Guide</a></li> </ul> <h4>Planning and Preparation</h4> <ul> <li><a href="els-nt40-plan-require.html">Requirements and Considerations</a></li> <li><a href="els-nt40-utilities.html">EtherLite Utilities</a></li> </ul> <h4>Setup</h4> <ul> <li><a href="els-nt40-master-setup.html">Master Setup Process</a></li> <li><a href="els-nt40-storeip.html">Assigning an IP Address: Store IP</a></li> <li><a href="els-nt40-bootp.html">Assigning an IP Address: Digi's Bootp</a></li> <li><a href="els-nt40-prmip-btcnsl.html">Assigning an IP Address (Permanent): Boot Console</a></li> <li><a href="els-nt40-tmpip-btcnsl.html">Assigning an IP Address (Temporary): Boot Console</a></li> <li><a HREF="els-nt40-drv-cd.html">Installing the Driver: CD</a></li> <li><a HREF="els-nt40-drv-dwnload.html">Installing the Driver: Downloaded</a></li> <li><a href="els-nt40-conf-config-modem.html">Configuring a Modem on a Digi Port</a></li> <li><a href="els-nt40-conf-config-printer.html">Configuring a Printer on a Digi Port</a></li> <li><a HREF="sts-nt40-drv-unstall.html">Uninstalling the Driver</a></li> </ul> <h4>Administration</h4> <ul> <li><a href="els-nt40-conf-port-nmbrs.html">Changing Serial Port Numbers</a></li> <li><a href="els-nt40-add-modules.html">Adding EtherLite Modules</a> </li> </ul> <h4>Reference</h4> <ul> <li><a href="els-btcnsl-cmmd-table.html">Boot Console Commands </a></li> </ul> <h4>Troubleshooting</h4> <ul> <li><a href="els-nt40-ping-prog.html">Using Ping </a> </li> <li><a href="els-nt40-verlog-utility.html">Using Verlog </a> </li> <li> <p align="left"><a href="els-xxxx-tsht-leds.html">EtherLite LEDs</a> </li> </ul> <h4>Related Documentation</h4> <ul> <li><a href="els-frameset.html" target="_blank">EtherLite Product Information</a></li> <li><a href="stel-cables.html">EtherLite Cable Guide</a></li> </ul> <HR> <P><i>Copyright © 2001, Digi International. <br> All rights reserved.</i> </P>