ATE STATIC SPECIFICATIONS

ATE Static specifications

NOTES:

  1. For models with output current ratings of 50A or higher, the load effect is 2mA typical and 5mA maximum. In slow mode, the leakage current through the output capacitor adds approximately 0-6mA to the current mode load effect.
  2. One terminal must be grounded for this measurement, or connected so that common mode current does not flow through the load or, in current mode, through the current-sensing resistor.
  3. Peak-to-peak ripple is measured over a 20Hz to 10MHz bandwidth.
  4. The output effect can be calculated by the relationship: (D = delta) DEo = DEr(Rf/Ri)DEio(1+Rf/Ri)D Iio(Rf) where Rf is the feedback resistor, and Ri is the input resistor from the reference, Er.
  5. For high voltage ATE 325-0.8M the maximum output ripple and noise is 10mV rms and 50mV p-p.