SPECIFICATIONS

DIELECTRIC WITHSTANDING VOLTAGE

200% of rated voltage applied through a minimum limiting resistance of 100 Ohms/Volt. Duration of voltage stress shall be 15 seconds minimum and 1 minute maximum at 25°C.

TEMPERATURE RANGE

-55°C to +85°C with full rated voltage applied. To +125°C with 50% of rated voltage.

INSULATION RESISTANCE

At 25°C after 2 minutes of electrification at rated voltage or 500 VDC, whichever is less, the minimum product of Insulation Resistance and Capacitance shall be 50,000 megohms-microfarads, but need not exceed 50,000 megohms.

DISSIPATION FACTOR

Shall not exceed 0.3% when measured at 25°C and 1000 Hz, ±20 Hz. See characteristic curves for D.F. ratings at other temperatures.

CAPACITANCE AND TOLERANCE

Shall be measured within the tolerance limits specified. Measurements will be made at 25°C and 1000 Hz, ±20 Hz.

LIFE TEST

Shall withstand 140% of rated voltage at 85°C for 250 hours. One failure in twelve shall be permitted.

CAPACITANCE STABILITY (DRIFT)

Less than 0.3% when measured in the following manner: three capacitance readings at 25°C, each made prior to and after temperature cycling from room to 85°C, and room to -55°C. The mathematical difference between the two extremes, divided by the intermediate value, and then multiplied by 100, yields the stability expressed in percent.

FEATURES

• Wrap and fill construction
  
  
• Micro-miniature -- lightweight
  
  
• Low dissipation factor
  
  
• Zero TC ±50 ppm/ °C from +25°C to +55°C
  
  
• Extended foil design
  
  
• Excellent stability
  
  
• Quality control procedures per Mil-Q-9858

APPLICATIONS

• Data Processing Equipment
  
  
• Aircraft and Missile Systems
  
  
• Industrial Instrumentation
  
  
• Navigation and Distance Measuring Equipment
  
  
• Communications equipment
  
  
• Tachometers
  
  
• Filters
  
  
• Peripheral Equipment

HUMIDITY RESISTANCE

Meets requirements of Mil-C-27287, Para. 3.12 when tested in accordance with Mil-STD.-202, Method 103 B, Condition B.

LEAD PULL AND BEND TEST

Steady pull of 5 pounds applied axially to leads for one minute. Bend test shall consist of one bend from the point of egress, first 90° in one direction, back to the original axial position, and then 90° in the opposite direction with no evidence of breakage.