View source for December 17th 2021

*Updates
**HCal

**Hodoscope

**BB Calorimeter
***HV in start of run
***need to check if HV in CODA file, Alex will check and give event type if in CODA file

**GRINCH
**CDet
**GEM Bigbite
***GEM working
**GEM INFN clean room
**Helicity 
**GEN RP
**beamline
***looking at BCM analysis
***working on putting helicity in tree, implemented but getting 0 so far so need to debug
**HV


*On-going tasks
**EPICS / start End of run logging script (fixed Bob 100% ) - just need to add configuration - will make a test configuration - need to make sure we have all variables - and variables to add at begining / end of run and during the run (EPICS 131 event - need to add to analyzer )  issue with ET  - could try run ER and EB on same node - way to restart ET ? 
***Carl looking at issues still unresolved - ER and ET communication - code updated - might fix issues - could try to update emu and ET to test

**(fixed database issue 100% working  ) David readout scalers fine and are in tree - from LHRS - still need SBS side will check with Steve - ( done - looks good on sbs side )
**script check MPD sync ( Ben , Andrew 20%) -  code to unpack information already written - need run with those data - timestamp need some work - ( event count aligned, timestamp look odd maybe will check with Andrew ) 
**sync check scripts other modules F1, 1190, FADC ( Andrew , Alex, Mark 20%) - Mark will work to have it available 
**reference channel to all crates - need HCal and Shower + RF - need to add RF to HCAL - 3 cables - in hodoscope crate - if shower FADC available can add 
separate - need RC box for shower and hodo if possible  -  need to check - module will be added ( Mark )
**Trigger latch TS to TDC ( Bob,Ole 100 % ) - trigger bank has latch 
**event type decoding in analyzer - ( done 100% ) - need update CH analyzer
***Possible new tasks
****User event inserted at each split with timestamp, spectrometer information - should discuss with 
****setup laptop for CH blujeans and Slack - need fix hard drive
**filling up google sheet with run info


*Unresolved issue
**(need to test)FADC bad channel - FADC replaced but problem could not be reproduce - need to test more ( on going - low priority ) - FADC in test lab - DAQ setup - need to feed signal
**(still there)warning PEB ROC - Bryan checking with Dave - might incorrect flag - not sure why - but data still in sync since only happens - still happening - not sure if it is an issue
**HV can put documentation for other non EPICS control
**(50%) near 100 MB/s limit for FADC crates - Shower window was divided by 2  - HCal windows - could do 150 ns - Move FADCs to top crate ? - can reach 5.2 KHz now
**(cannot be fixed - been that way forever) Raster X1 vs Raster X2 anticorrelation
**No clear signal in GRINCH - latency was adjusted - need check with beam ( see signal now ) - Event display
- adjust LED timing to match physics event -
*3820 scalers : issue to address - will get more as spare - and need - 
* 75 ns timing shift 
*( new) DAQ running with APV and MPD in bad state


GEn RP
*GEN RP DAQ


*To do list during break
**Must
***timing diagram, diagnostic time shift
***fix bad APVs
***HV network boot
***cosmics for HCAL - 




**Like
***VETROC HCAL
***Shower FADC trigger
***HCAL FADC trigger