View source for Luminosity Scans - Low Rate (Target Boiling)

<table border="1"  style="width:80%">
  <tr>
    <td>E<SUB>beam</SUB> [GeV]</td>
    <td>P<sub>0</sub> [GeV/c]</td> 
    <td>&theta;<SUB>e</SUB> [deg]</td>
    <td>Collimator</td>
    <td>Target</td>
    <td>Fast Raster <br> X x Y </td>
    <td>Beam Current</td>
  </tr>
  <tr>
    <td>7.3</td>
    <td>3.056</td> 
    <td>25</td>
    <td>6 mSr</td>
    <td>Carbon Optics</td>
    <td>1 mm x 1 mm</td>
    <td>variable</td>
  </tr>
</table><br>

Perform luminosity scans with targets and beam currents listed below.  For the Dummy target, we might have to stay below 40 &mu;A.  These combined with a low rate scan should allow us to determine if there is any rate dependent systematic.  A 90 &mu;A, the hydrogen electron rates should be ~ 1.4 kHz.
<ol>
<li> Make sure the info (fan speed, temp, ...)  for both loops are in the end/start run epics scripts.
<li> Hydrogen scan. Take HRS runs at 10, 20, 30, 45, 60, 75 and 90 &mu;A.
<li> Carbon scan. Take HRS runs at 10, 20, 30, 45, 60, 75 and 90 &mu;A.
<li> Aluminum dummy scan. Take Take HRS runs at 10, 20, 30, 40 &mu;A.
</ol>