Difference between revisions of "How to start EDTM pulser (experts only)"
From Hall A Wiki
| Line 5: | Line 5: | ||
The meaning of the arguments are explained below. | The meaning of the arguments are explained below. | ||
| − | 3 To quit from telnet, hold the ctrl key and hit "]". we should then see a prompt like "telnet>". Now type '''q''' to close the connection. | + | 3 To quit from telnet, hold the "'''ctrl'''" key and hit "''']'''". we should then see a prompt like "telnet>". Now type "'''q'''" to close the connection. |
Revision as of 11:28, 6 October 2014
1 Open a terminal from any computer in counting house and type the command:
->telnet hatsv4 2004
2 After connecting to that port and hitting the enter key, a prompt should pop up and we can set the EDTM pulser rate by the following command:
->r_pulser_Start(0,0xa100,0xc339)
The meaning of the arguments are explained below.
3 To quit from telnet, hold the "ctrl" key and hit "]". we should then see a prompt like "telnet>". Now type "q" to close the connection.
