Difference between revisions of "SBS DAQ meetings"

Revision as of 11:16, 25 October 2019

Bluejeans

HCAL DAQ status ( Scott )
- 2 crates : 1 VXS crates with FADC and 1 VME64X with F1 and FADC

- see cosmics in both crates in FADC , missing in TDC ( need to check new timing with 2 crates )

- resolution lock issue with F1, might be overheating

- add blanks to improve cooling

- reduce resolution of F1 to see if problem goes away

- latency from TI ( OT2 is prompt output less delay down to 200 ns)

- 3 VME crates in clean room with TI ( 2 VME and 1 VXS ) : 2 planes per crate , 1 TI and one fiber, need 1 TI with two transceiver

- using CODA3

- wiki with information on wiki : SBS_DAQ:_GEM_EEL_Cleanroom_setup

- computer ready soon

- 3rd (VXS) crate with SSP and MPDs

- 16 MPD for 1 SSP to be tested

- all transceiver and fibers on site

- test radiation hardness of transceivers and fibers

- daughter board design done, need to make prototypes and test

CDet
- All TDC for coordinate in weldment : need checks ?
- Software : running DAQ CODA and root scripts to analyze, need to check if other functionalities needed. Library can be loaded in Hall A / SBS analyzer
- amount of TDCs for CDet sufficient
- 25 TDCs - need to check with Bob

@@ Line 7: / Line 7: @@
 *Detectors DAQ status
 **BigBite
+*** ADCs working fine running with CODA 2
+*** signals from all shower preshower channels
+*** can look at data with scripts
+*** add TDCs to setup (27x7 + 2x27 ) = 243 channels, only sums so 52 channels ( 1 x 1877S )
+*** try CODA3
 **HCal
+***FADC and F1 all running on HCAL
+***resolution checks, not good right now, might be due to discriminator ( Phillips 715 )
+***looking at cosmics
+***all cables for second half of HCAL
+*** still unlock error on 1 TDC , need try lower resolution
+*** still on CODA2
 *CODA3 testing (Bob) [https://hallaweb.jlab.org/wiki/images/f/f4/CODA3_Exp.pdf pdf]