Difference between revisions of "Starting CODA for shift workers"
From Hall A Wiki
| Line 12: | Line 12: | ||
*If needed use Rstart CODA components | *If needed use Rstart CODA components | ||
| − | *In runcontrol make sure sbsts session is chosen and config | + | *In runcontrol make sure sbsts session is chosen and config GMN1nosbsvme20 is choosen |
*To start a run | *To start a run | ||
| Line 18: | Line 18: | ||
**hit configure button in runcontrol, might need to hit it twice if vtpROC20 misses the first configuration | **hit configure button in runcontrol, might need to hit it twice if vtpROC20 misses the first configuration | ||
**hit download button | **hit download button | ||
| + | **check prescale factors ( To open prescale gui : ssh to sbs-onl@adaq2 and type prescale ) | ||
**hit Start Run button | **hit Start Run button | ||
| + | **fill in run information in pop up box ( make sure you have correct target / runtype ) | ||
Revision as of 07:37, 7 October 2021
- DAQ should be running on hadesk4 in a VNC
- If the VNC is not opened, or after logging in as adaq
type : RunCoda
VNC password is adaq password
alternatively connect on vnc on adaq2:4
- Use CODA scripts buttons on first Desktop to start the ROC Xterms and Run Control
- If needed use Rstart CODA components
- In runcontrol make sure sbsts session is chosen and config GMN1nosbsvme20 is choosen
- To start a run
- hit configure button in runcontrol, might need to hit it twice if vtpROC20 misses the first configuration
- hit download button
- check prescale factors ( To open prescale gui : ssh to sbs-onl@adaq2 and type prescale )
- hit Start Run button
- fill in run information in pop up box ( make sure you have correct target / runtype )
