Difference between revisions of "June 30 2011 Meeting Summary"
From Hall A Wiki
(One intermediate revision by the same user not shown) | |||
Line 26: | Line 26: | ||
hyao: | hyao: | ||
− | # Acceptance is independent of target. So recalculate the acceptance with turning off the radiative in SAMC. | + | # Acceptance is independent of target. So recalculate the acceptance with turning off the radiative in SAMC. <font color=red>---->Disable multi-scattering and energy loss in SAMC.--[[User:Hyao|hyao]] 10:01, 1 July 2011 (UTC)</font> |
− | # Compare the cross section of the right arm without/with pre-shower/shower cut. | + | # Compare the cross section of the right arm without/with pre-shower/shower cut.<font color=red>---->Done but still see difference.--[[User:Hyao|hyao]] 10:01, 1 July 2011 (UTC)</font> |
− | # Compare cross section between two arms with gc cut only. | + | # Compare cross section between two arms with gc cut only.<font color=red>---->Done but still see difference.--[[User:Hyao|hyao]] 10:01, 1 July 2011 (UTC)</font> |
− | # Calculate the RC for previous cross sections to see the result. | + | # Calculate the RC for previous cross sections to see the result.<font color=red>---->Done.--[[User:Hyao|hyao]] 10:01, 1 July 2011 (UTC)</font> |
− | # Find where constant factor is from for 90,120? | + | # Find where constant factor is from for 90,120?<font color=red>---->Done. I think it's because of low energy optics of right arm.--[[User:Hyao|hyao]] 10:01, 1 July 2011 (UTC)</font> |
− | + | ||
− | + |
Latest revision as of 10:03, 14 July 2011
Back to CSR Weekly Meeting on 2011
- hyao: [cross section for Fe]
- xinhu: [Cross section comparison between left and right arm for 60 deg]
- xinhu: [Cross section comparison between left and right arm for 90 deg]
- xinhu: [Acceptance Plot Corrected]
xinhu:
- Acceptance region is so small that it may easily cause large error.
hyao:
- 90,120 deg has one constant scale factor offset between left and right.
- 60 deg, it seems wrong angle for left arm after first period or it may be caused by radiative correction because of different oriented target.
To do list:
xinhu:
- correct efficiency for the bad block , THaShower.C
- do the simulation of acceptance for the full region of NaI (box2 and box3) and check the efficiency correction for bad blocks of NaI
- and then calculate the cross sections for the left arm
hyao:
- Acceptance is independent of target. So recalculate the acceptance with turning off the radiative in SAMC. ---->Disable multi-scattering and energy loss in SAMC.--hyao 10:01, 1 July 2011 (UTC)
- Compare the cross section of the right arm without/with pre-shower/shower cut.---->Done but still see difference.--hyao 10:01, 1 July 2011 (UTC)
- Compare cross section between two arms with gc cut only.---->Done but still see difference.--hyao 10:01, 1 July 2011 (UTC)
- Calculate the RC for previous cross sections to see the result.---->Done.--hyao 10:01, 1 July 2011 (UTC)
- Find where constant factor is from for 90,120?---->Done. I think it's because of low energy optics of right arm.--hyao 10:01, 1 July 2011 (UTC)