Difference between revisions of "Make sure laser flipping is on"
From Hall A Wiki
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | The script that cycles the Compton laser lock on and off should be run from the vncserver on compton | + | The script that cycles the Compton laser lock on and off should be run from the vncserver on compton (compton:005). I typically run it in a terminal from the bottom left workspace. |
The script is located in: | The script is located in: | ||
| Line 10: | Line 10: | ||
Flags: | Flags: | ||
| − | + | ||
| − | + | # "flip" means cycle the laser on and off. | |
| − | + | # bcm_threshold: minimum beam current for script to execute | |
| − | + | # time_off: time for laser off period in seconds | |
| − | + | # time_on: time for laser on in seconds | |
| + | # power_threshold: cavity power threshold above which the time_on counter begins | ||
| + | |||
| + | |||
I typically run the script as follows: | I typically run the script as follows: | ||
cavity_C_gaskell flip -1 30 90 100 | cavity_C_gaskell flip -1 30 90 100 | ||
Latest revision as of 16:04, 21 June 2019
The script that cycles the Compton laser lock on and off should be run from the vncserver on compton (compton:005). I typically run it in a terminal from the bottom left workspace.
The script is located in:
/home/compton/gaskelld/cavity_script
And should be run as follows:
cavity_C_gaskell flip <bcm_threshold> <time_off> <time_on> <power_threshold>
Flags:
- "flip" means cycle the laser on and off.
- bcm_threshold: minimum beam current for script to execute
- time_off: time for laser off period in seconds
- time_on: time for laser on in seconds
- power_threshold: cavity power threshold above which the time_on counter begins
I typically run the script as follows:
cavity_C_gaskell flip -1 30 90 100
