Difference between revisions of "Thursday, Apr. 14: SWINGShift"

Latest revision as of 18:41, 14 April 2016

Return to List of Daily Run Plans

Shift Duties

• Take Production data
• If Beam has been down for longer than 3 hours:
  • Perform Reestablish Beam Procedure

Completed works

1/ MCC beam study (8:00AM-2:00PM)

2/ During this time,

 a)  Radcon access to Hall  for replacing Hall-A Dump diffuser Interlock VME card with new firmware (ion chamber check) ELOG:3398771
 b)  MCC will check FFB in the SL (2L26 region) ELOG:3398780

Ongoing

3/ Establishing beam Compton chicane (Jay+Cip + Juan Carlos are aware of this !)

parity check ?

SINCE 5TH PASS RF SEPARATOR FAILED: (1hrs recovery, we get behind schedule) WE DECIDE TO POSTPONE THE COMPTON NEXT MONDAY, LASER IS OFF

( 5th pass separator trip + Capture GMES low/Temp high + A/D laser phase change + Checking separation )

BEAM IS GOING TO BE STRAIGHT TO LH2 FOR NOMINAL PRODUCTION MODE TONIGHT

Production Running

For the remainder of the shift take 1 hour runs in the production configuration DVCS: Kin_48_4

Reestablish Beam Procedure

This procedure is to be run every time we recover from an extended beam down (>3 hours).

• Harp Scans
  • Move target to HOME position (if not already there) (mask target motion!)
  • Turn VDC HV OFF for both arms.
  • Turn DVCS Calo HV OFF
  • Ask MCC for Raster OFF (check that it turns off in the scope)
  • Ask MCC to perform Harp Scans (on IHA1H04A and IHA1H04B)
    • Must have three peaks on each with a resolution of ~200-500 μm
    • Have seen a "shoulder" on the last peak before. May be acceptable if other 2 peaks are fine.
  • Ask MCC to make an ELOG with the results of the Harp Scans
• Beam Centering on Carbon Hole Target
  • Move target to the Carbon Hole position (mask target motion!)
  • Ensure Left-HRS momentum is ~1 GeV/c
  • Set Left-HRS DAQ configuration to LeftHRSnew
    • Set prescales as ps_i = 1 for i = 1-6, and ps=0 for all others
  • Turn VDC HC OFF for both arms.
  • Turn DVCS Calo HV OFF
  • Ask MCC for Raster ON at 2x2 or whatever is on the whiteboard
    • Check that it turns on in the scope, and check Raster GUI to confirm 2x2 setting
  • Ask MCC for 5 μA beam
    • Run spot_L as explained in the detailed instructions
    • If not centered ask MCC to move beam accordingly (check board for coordinates)
    • Repeat test with different beam position until target is centered.
• Raster Target
  • Start the same settings as carbon hole centering
  • Move to Raster Target (mask target motion!)
  • Ask MCC for 5uA beam with Raster ON (2x2)
  • Check rates and confirm they are consistent with rates seen during HOME position
    • If the rates are low and consistent, then move on to next step
    • If the rates are high, it may indicate the beam has an angle that causes the beam to scrape on an edge of the target
      • Notify the RC
      • Ask MCC to readjust BPM positions until this angle is removed
      • When done, perform another Carbon Hole run just to be sure.