Difference between revisions of "Fall 2016 calorimeter calibration (elastic)"
From Hall A Wiki
| (5 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | Back to [[https://hallaweb.jlab.org/wiki/index.php/ | + | Back to [[https://hallaweb.jlab.org/wiki/index.php/Run_Plan_%28DVCS3%29 Back to the DVCS3 run plan page]] |
'''This is in progress (09-20-16 contact J. Roche)''' | '''This is in progress (09-20-16 contact J. Roche)''' | ||
| Line 13: | Line 13: | ||
beam energy= 6.4 GeV<br> | beam energy= 6.4 GeV<br> | ||
| − | We will take about | + | We will take about '''2 hours''' beam with each of the following three calorimeter angles: 21.4, 22.7 and 24.0 deg. |
| + | The plot below shows calculation for the case where we would move the calorimeter and the LHRS for each kinematic point. | ||
| − | [[Image: | + | [[Image:DVCS3 Fall 2016 elastic.jpg| 1000px]] |
Latest revision as of 14:18, 20 September 2016
Back to [Back to the DVCS3 run plan page]
This is in progress (09-20-16 contact J. Roche)
Need to remove the plastic shield.
Calorimeter-Target distance =6.0m
LH2 target, unrastered beam (which means beam current at less than 5 uA).
LHRS in positive polarity.
Open LHRS collimator
DAQ: DVCS config, trigger is S0+S2, autovalidation.
angleLHRS= 32.50 [deg]
momentum LHRS= 3.0 GeV
beam energy= 6.4 GeV
We will take about 2 hours beam with each of the following three calorimeter angles: 21.4, 22.7 and 24.0 deg.
The plot below shows calculation for the case where we would move the calorimeter and the LHRS for each kinematic point.
