Difference between revisions of "Thursday, Mar. 03: SWING Shift"

Revision as of 21:48, 3 March 2016

Go back to Daily Run Plan Daily Run Plans

Previously...

>> HALOG [1]

- RF recovery done, Prepare the BCM calibration (not happened due to delay restoring the beam)
- Set up beam through Compton chicane

Specific mission

1/ Set up beam through Compton chicane
- Ciprian, Greg and Yves are tuning the beam through Compton
2/ Expect some production runs through Compton

3/ Agreement with Hall-D and Talked PD to set up the BCM calibration tomorrow

(high beam current 30uA with FC & empty target)

Instruction: DOC1 DOC2
- Experts on call (Dave/Julie/Thir/...) - Calo. HV off

BPM/Spot++ Check

After beam lost for considerable time (like beam study, pass change,...)
Ask MCC to run 5uA wth carbon hole target and make sure you can see the hole through Spot++

@@ Line 1: / Line 1: @@
 Go back to Daily Run Plan [[Daily Run Plans]]
-* General considerations
-**
+<b>Previously...</b>
+** Complete energy measurement with series of Hall-A magnet (mapping)<br>
+>> HALOG [https://logbooks.jlab.org/entry/3387270]
+** RF recovery done, Prepare the BCM calibration (not happened due to delay restoring the beam)
+** Set up beam through Compton chicane
 <b>Specific mission</b>
 * Note:
+/  Set up beam through Compton chicane<br>
+- Ciprian, Greg and Yves  are tuning the beam through Compton<br>
+/ Expect some production runs through Compton <br>
+/ Agreement with Hall-D and Talked PD to set up the BCM calibration tomorrow<br>
+ (high beam current 30uA with FC & empty target)<br>
+Instruction:
+[http://hallaweb.jlab.org/equipment/BCM/HallA_BCM_linearity.pdf DOC1][http://hallaweb.jlab.org/equipment/BCM/HallA_Unser_0L02_cal.pdf DOC2]
+<br>
+- Experts on call (Dave/Julie/Thir/...)
+- Calo. HV off<br>
-* Detailed instructions [https://hallaweb.jlab.org/ here]