Difference between revisions of "Remaining GEn-RP install tasks"

Revision as of 16:07, 28 March 2024

SBS GEMs:
- techs to install final shielding blocks around the electronics hut
- Check low-levels, cosmics
- Techs to install scintillators next week

Readout:
- Balance VTP fibers amongst crates to optimize (after GEMs are installed)

High voltage:
- move HV to working reboot strip (done, but need to add to gui)
- Add variables to accelerator to request for archiving

@@ Line 1: / Line 1: @@
 * SBS side LV:
-** Joe to connect, instruct on controls (DONE!)
+** Ellen to install some controller and readback (in progress)
-** Ellen to install some controller and readback (in progress, Ellen working with accelerator)
-** Input the jumpers on the breakout panel (DONE!)
-** Run the cables (in progress, Armen adding connectors)
 * SBS GEMs:
-** Install XW into stack (DONE!)
-** Finish signal cabling (asap)
-** Connect to HV patches (after HDMI cabling complete)
-** reconnect gas to RP layers (after BB XY work?)
 ** techs to install final shielding blocks around the electronics hut
+** Check low-levels, cosmics
+** Techs to install scintillators next week
 * BB GEMs:
-** Upgrade the XY HV, re-install (do we need to do this now?)
+** Check low-levels, cosmics
 * Readout:
 ** Balance VTP fibers amongst crates to optimize (after GEMs are installed)
-** Ensure that reboot/troubleshooting script works for all crates (DONE!)
 * High voltage:
-** Finish channels in GUI (DONE!)
 ** move HV to working reboot strip (done, but need to add to gui)
-** finalize script for GUI upload of HV and operation (DONE!)
+** Add variables to accelerator to request for archiving
 * Update the documentation on the HV and LV operations (before beam)
 * GEM experts on call (setup before beam)
-* Clean up our areas (should start now, little by little)
+* Clean up our areas (in progress)