Difference between revisions of "E08-014 Run Plan"
From Hall A Wiki
(→1st phase: Helium-4, Deuterium and Carbon running) |
(→1st phase: Helium-4, Deuterium and Carbon running) |
||
| Line 164: | Line 164: | ||
|} | |} | ||
- Rate/Boiling study on 4He, deuterium and carbon (4 hours) | - Rate/Boiling study on 4He, deuterium and carbon (4 hours) | ||
| + | - BCM calibration | ||
- Bullseye scan (?) | - Bullseye scan (?) | ||
Revision as of 15:28, 16 April 2011
Contents
- 1 Kinematics Plot
- 2 Reconfiguration, Commissioning and Calibration 1st phase (Starting on April 15 at 9:30am)
- 3 1st phase: Helium-4, Deuterium and Carbon running
- 4 Target switch: 3 days down (Starting on April 26 at 8am)
- 5 Calibration 2nd phase (Starting on April 29 at 8am)
- 6 2nd phase: Helium-3 and Calcium running (Starting on April 29 at 5pm)
Kinematics Plot
Reconfiguration, Commissioning and Calibration 1st phase (Starting on April 15 at 9:30am)
- Energy change: 4 pass --> 3 pass (2-3 hours)
1) Change Right HRS polarity to negative
2) Left & Right HRS at kin 5.2: theta=25deg, Po=2.995GeV/c (RQ3=2.6273GeV/c)
- Set up for maximum current (95 uA)
- BCM calibration (1 hour)
1st phase: Helium-4, Deuterium and Carbon running
The 4He and 2H might not be ready for beam simultaneously. Therefore, the plan is to take data on 4He, then move to carbon. During the data taking on carbon, lower the cryo-load on 4He and prepare 2H for beam (it should take 5 min). Take data on 2H. Then on optics. Then switch kinematics and do the same thing in reverse order: Optics --> 2H --> Carbon --> 4He.
| Kin | Ein [GeV] | Po (GeV) | Theta | x-region | Q^2-range | Target | I (uA) | prescale | # good evts | time(hrs) | total time | # evts accumulated | |
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Tight cuts | Loose cuts | ||||||||||||
| 5.2 | 3.356 | 2.995 (RQ3=2.6373GeV/c, I=1049.2A) | 25.0 | 3N SRC | 1.82-2.00 |
4He (#1) Carbon (#2) |
95 95 |
1 1 |
64500 64200 |
12.6
4.2
|
16.8 |
60339 ? |
1275555 ? |
| 5.1 | 3.356 | 2.795 (RQ3=2.4519GeV/c, I=????A) | 25.0 | 2N SRC | 1.70-1.82 |
4He (#3) Carbon (#2) 2H (#1) |
95 95 60 |
1 1 1 |
482900 475400 553200 |
2.9
1.1
2.9
|
6.9 |
? ? ? |
? ? ? |
| 5.0 | 3.356 | 2.505 (RQ3=2.1975GeV/c, I=????A) | 25.0 | QE | 1.52-1.63 |
4He (#1) Carbon (#2) 2H (#3) BeO (#4) Optics (#5) |
95 95 60 5 5 |
2 2 11 1 1 |
n/a n/a n/a n/a n/a |
1
1
1
10-15min
10-15min
|
3 + 0.5 |
? ? ? n/a n/a |
? ? ? n/a n/a |
- Rate/Boiling study on 4He, deuterium and carbon (4 hours) - BCM calibration - Bullseye scan (?)
| Kin | Ein [GeV] | Po (GeV) | Theta | x-region | Q^2-range | Target | I (uA) | prescale | # good evts | time(hrs) | total time | # evts accumulated | |
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Tight cuts | Loose cuts | ||||||||||||
| 3.2 | 3.356 | 3.055 (RQ3=2.6800GeV/c, I=????A) | 21.0 | 3N SRC | 1.31-1.41 |
4He Carbon |
95 95 |
1 1 |
213200 204000 |
0.8
0.3
|
1.1 |
? ? |
? ? |
| 3.1 | 3.356 | 2.905 (RQ3=2.5484GeV/c, I=????A) | 21.0 | 2N SRC | 1.25-1.34 |
4He Carbon 2H optics |
95 95 60 5 |
2 2 3 1 |
3044800 2880900 3500000 n/a |
1.7
0.6
2.7
0.5
|
5.0 + 0.5 |
? ? ? n/a |
? ? ? n/a |
| 4.2 | 3.356 | 3.035 (RQ3=2.6624GeV/c, I=????A) | 23.0 | 3N SRC | 1.56-1.68 |
4He Carbon |
95 95 |
1 1 |
62400 60900 |
1.6
0.6
|
5.1 |
? ? |
? ? |
| 4.1 | 3.356 | 2.855 (RQ3=2.5045GeV/c, I=????A) | 23.0 | 2N SRC | 1.47-1.58 |
4He Carbon 2H optics |
95 95 60 5 |
1 1 1 1 |
813000 789700 900000 n/a |
1.1
0.4
1.1
0.5
|
2.6 + 0.5 |
? ? ? n/a |
? ? ? n/a |
Target switch: 3 days down (Starting on April 26 at 8am)
Calibration 2nd phase (Starting on April 29 at 8am)
- Boiling study on 3He (4 hours) - Rate-dependence tests (4 hours) - BCM calibration (1 hour)
2nd phase: Helium-3 and Calcium running (Starting on April 29 at 5pm)
The time listed in red is the total time needed. It should be divided by two if the kinematics point is taken simultaneously by the the two HRSs.
Total time needed: 619 hours/2 = 309.5 hours per HRS (production) + 4.0 hours (optics)
+ 8.7 hours (52*10min for target motion) + 5 hours (10*30min for kin change)
= 327 hours (13.6 PAC days = 27.3 calendar days).
We have only 13.6 calendar days till May 13 8am. Need to cut !!!
| Kin | Ein [GeV] | Po (GeV) | Theta | x-region | Q^2-range | Target | I (uA) | prescale | time(hrs) | total time |
|---|---|---|---|---|---|---|---|---|---|---|
| 1 | 3.356 | 3.155 | 16 | 2N + 3N SRC | 0.79-0.85 |
3He Carbon Ca-40 Ca-48 dummy optics |
84 100 40 40 40 ? |
7 9 5 5 ? 1 |
3.0
0.8
1.3
1.3
1.0
0.5
|
7.4 + 0.5 |
| 2 | 3.356 | 3.110 | 18.5 | 2N + 3N SRC | 1.04-1.12 |
3He Carbon Ca-40 Ca-48 dummy optics |
84 100 40 40 40 ? |
1 1 1 1 1 1 |
3.6
0.8
2.2
2.3
1.1
0.5
|
10.0 + 0.5 |
| 3.1 | 3.356 | 2.905 | 21.0 | 2N SRC | 1.25-1.34 |
3He Carbon Ca-40 Ca-48 dummy optics |
84 100 40 40 40 ? |
2 2 1 1 1 1 |
3.6
1.1
1.8
1.9
1.1
0.5
|
13.6 + 0.5 |
| 3.2 | 3.356 | 3.055 | 21.0 | 3N SRC | 1.31-1.41 |
3He Carbon Ca-40 Ca-48 dummy |
84 100 40 40 40 |
1 1 1 1 1 |
4.5
1.0
2.8
2.9
1.4
|
12.6 |
| 4.1 | 3.356 | 2.855 | 23.0 | 2N SRC | 1.47-1.58 |
3He Carbon Ca-40 Ca-48 dummy optics |
84 100 40 40 40 ? |
1 1 1 1 1 1 |
4.5
1.4
4.5
4.7
1.4
0.5
|
16.5 + 0.5 |
| 4.2 | 3.356 | 3.035 | 23.0 | 3N SRC | 1.56-1.68 |
3He Carbon Ca-40 Ca-48 dummy |
84 100 40 40 40 |
1 1 1 1 1 |
9.0
2.0
5.5
5.7
2.7
|
24.9 |
| 5.1 | 3.356 | 2.795 | 25.0 | 2N SRC | 1.70-1.82 |
3He Carbon Ca-40 Ca-48 dummy optics |
84 100 40 40 40 ? |
1 1 1 1 1 1 |
9.0
2.8
8.9
9.4
2.7
0.5
|
32.8 + 0.5 |
| 5.2 | 3.356 | 2.995 | 25.0 | 3N SRC | 1.82-2.00 |
3He Carbon Ca-40 Ca-48 dummy |
84 100 40 40 40 |
1 1 1 1 1 |
18.0
4.1
11.1
11.6
5.4
|
50.2 |
| 6 | 3.356 | 2.885 | 27.0 | 3N SRC | 2.04-2.18 |
3He Carbon Ca-40 Ca-48 dummy optics |
84 100 40 40 40 ? |
1 1 1 1 1 1 |
36.0
8.2
22.3
23.1
10.8
0.5
|
100.4 + 0.5 |
| 7 | 3.356 | 2.835 | 29.0 | 3N SRC | 2.30-2.47 |
3He Carbon Ca-40 Ca-48 dummy optics |
84 100 40 40 40 ? |
1 1 1 1 1 1 |
63.0
14.3
38.8
40.3
18.9
0.5
|
175.3 + 0.5 |
| 8 | 3.356 | 2.790 | 31.0 | 3N SRC | 2.58-2.77 |
3He Carbon Ca-40 Ca-48 dummy |
84 100 40 40 40 ? |
1 1 1 1 1 1 |
63.0
14.4
38.8
40.3
18.9
0.5
|
175.4 + 0.5 |
