Difference between revisions of "Thursday, Mar. 03: SWING Shift"
From Hall A Wiki
| Line 17: | Line 17: | ||
1/ Set up beam through Compton chicane<br> | 1/ Set up beam through Compton chicane<br> | ||
- Ciprian, Greg and Yves are tuning the beam through Compton<br> | - Ciprian, Greg and Yves are tuning the beam through Compton<br> | ||
| + | - HALOG [https://logbooks.jlab.org/entry/3387530] | ||
2/ Expect some production runs through Compton <br> | 2/ Expect some production runs through Compton <br> | ||
Revision as of 22:01, 3 March 2016
Go back to Daily Run Plan Daily Run Plans
Previously...
- Complete energy measurement with series of Hall-A magnet (mapping)
- HALOG [1]
- RF recovery done, Prepare the BCM calibration (not happened due to delay restoring the beam)
- Set up beam through Compton chicane
Specific mission
- Note:
1/ Set up beam through Compton chicane
- Ciprian, Greg and Yves are tuning the beam through Compton
- HALOG [2]
2/ Expect some production runs through Compton
3/ Agreement with Hall-D and Talked PD to set up the BCM calibration tomorrow
- Crucial: high beam current 30uA with FC & empty target
Instruction:
DOC1DOC2
- Experts on call (Dave/Julie/Thir/...)
- Calo. HV off
BPM/Spot++ Check
- After beam lost for considerable time (like beam study, pass change,...)
- Ask MCC to run 5uA wth carbon hole target and make sure you can see the hole through Spot++
