Difference between revisions of "Make sure laser flipping is on"
From Hall A Wiki
(New page: The script that cycles the Compton laser lock on and off should be run from the vncserver on compton-old (compton-old:005). I typically run it in a terminal from the bottom left workspace....) |
|||
| Line 10: | Line 10: | ||
Flags: | Flags: | ||
| − | 1 | + | [1] "flip" means cycle the laser on and off. |
| − | 2 | + | [2] bcm_threshold: minimum beam current for script to execute |
| − | + | [3] time_off: time for laser off period in seconds | |
| − | + | [4] time_on: time for laser on in seconds | |
| − | + | [5] power_threshold: cavity power threshold above which the time_on counter begins | |
I typically run the script as follows: | I typically run the script as follows: | ||
cavity_C_gaskell flip -1 30 90 100 | cavity_C_gaskell flip -1 30 90 100 | ||
Revision as of 14:21, 29 March 2016
The script that cycles the Compton laser lock on and off should be run from the vncserver on compton-old (compton-old:005). I typically run it in a terminal from the bottom left workspace.
The script is located in:
/home/compton/gaskelld/cavity_script
And should be run as follows:
cavity_C_gaskell flip <bcm_threshold> <time_off> <time_on> <power_threshold>
Flags: [1] "flip" means cycle the laser on and off. [2] bcm_threshold: minimum beam current for script to execute [3] time_off: time for laser off period in seconds [4] time_on: time for laser on in seconds [5] power_threshold: cavity power threshold above which the time_on counter begins
I typically run the script as follows:
cavity_C_gaskell flip -1 30 90 100
