Difference between revisions of "Crate resets"

Revision as of 19:38, 13 October 2022

BigBite_trigger_and_DAQ

• VXS crates power supplies controls (open in browser on VNC)
  • http://hcalvxs1.jlab.org HCAL bottom crate
  • http://hcalvxs2.jlab.org HCAL top crate
  • http://bbhodovxs.jlab.org hodoscope crate
  • http://sbsgemcrate02.jlab.org SBS GEM crate 02 (sbsvtp2)
  • http://sbsgemcrate01.jlab.org SBS GEM crate 01 (sbsvtp2)
  • http://hallavme12.jlab.org BB GEM crate
  • http://grinchvxs.jlab.org GRINCH crate
  • http://lefthrsvxs.jlab.org HRS crate
  • http://bbshowervxs.jlab.org BB Shower VXS crate

• CAEN crate'
  • ssh sbs-onl@intelbbmpd
  • type minicom, if error do a "killall minicom" wait a minute and try again
  • tyoe CAEN
  • choose c
  • turn off and on the crate
  • exit from menu

• Powerstrips
  • http://hareboot6.jlab.org
    • INFN crate port 7
    • BB UVA crate port 6
  • http://hareboot32.jlab.org
    • BB UVA GEM LV port 5
    • Trigger distribution box
  • http://hareboot14.jlab.org
    • GRINCH gas panel camera switch 1
    • GRINCH LED pulser switch 8
  • Detailed Instructions on Power Cycling + hareboot14 Device List
  • http://129.57.188.119
    • enpcamsonne PC port 4
    • HCal/BBCal Threshold Readback rpi port 8
  • http://prexreboot01.jlab.org
    • SBS MPD crate0 (sbsvme32) port 1
    • SBS MPD crate1 (sbsvme30) port 2
  • http://prexreboot02.jlab.org
    • SBS MPD crate2 (sbsvme25) port 1
    • SBS UVA Inline GEM LV port 2
    • Port 3-7 Fan In/Out modules

• Portservers
  • bbps1
    • port 3 sbsvtp1
    • port 4 sbsvtp3

• INFN GEM LV
  • The INFN low voltage is accessible by browser. This low voltage control has two channels: channel 1 controlslayer J0, and channel 2 controls layer J2. The operation manual for the low voltage power supply, whichincludes a remote control command list, can be found: CPX400DP.The following instructions can be usedto access the INFN low voltage power supply:1. Open a firefox browser (from network)2. In address bar, type: 129.57.188.51 (for BigBite LV supply)3. Click on Instrument Control4. TypeOPALL 0to turn off. TypeOPALL 1to turn on