Difference between revisions of "Lab Records"

Latest revision as of 17:15, 7 December 2010

Oven is tested on Mar 24, 2010 without cell. Gas flow is 5~6 in mechanical meter, 508 on digital meter.

If turn on the constant heater only (set temperature -> 20C), heater temp reached 212C, oven reached 154C

Air flow meter in oven control chassis is cross calibrated with mechanical air flow meter at target.

Alarm 4 is set at 280.

@@ Line 1: / Line 1: @@
+=== TODO List ===
+* {{pass |Clean and organize target lab}}
+* {{pass |Around He3 Cell}}
+** {{pass |Oven positioning}}
+** {{pass |Holding field hardware}}
+** {{pass |Air flow test}}
+** {{pass |Heater test}}
+** {{pass |Setup RTD reader}}
+** {{pass |Setup spectrometer}}
+** {{pass |Install He3 cell}}
+** {{pass |Install target chamber pickup coils}}
+** {{pass |Attach RTDs}}
+* {{pass |Laser Subsystem}}
+** {{pass |Cleaning optics stuff}}
+** {{pass |[[Target_Lab_Main#1.2F4-Wave_Plate_Calibration | Q-wave plate calibration]]}}
+** {{pass |Install optics}}
+** {{pass |low power alignment}}
+** {{pass |High power check}}
+** {{pass |Optical Pumping Operational}}
+* NMR Polarimetery
+** {{pass |NMR RF Delivery}}
+** {{pass |Pumping chamber pick up coil setup}}
+** {{pass |Target chamber pick up coil setup}}
+** {{pass |pick up coil alignment}}
+** {{pass |NMR code}}
+** {{pass |NMR Operational}}
+** {{warning|water NMR}}
+* {{pass |EPR Polarimetery}}
+** {{pass |EPR RF Delivery}}
+** {{pass |D2 light collection}}
+** {{pass |EPR code}}
+** {{pass |EPR line shape}}
+** {{pass |EPR frequency lock}}
+** {{pass |EPR Operational}}
 === Cell Installed, Arp 04, 2010 ===