Procedure with Sieve-slit
* A Hall A Tech may be required to install the 2-inch lead sieve-slit collimator onto the front face of the HRS.
* Take a sieve slit run with the multi-foil carbon target for the inelastic kinematics in the table.
* If you need to increase the spectrometer momentum setting, make sure you cycle Q2 and Q3 as per the cycling procedure.
* Repeat the above with the beam position shifted so that you see a vertical shift by one row.
* Rates assume 5 carbon foils, only 9 out of 25 sieve holes have events (~ 0.146 mSr acceptance), and 9% delta acceptance.
| Ebeam [GeV] |
P0 [GeV/c] |
θe [deg] |
Q2 [GeV2] |
W [GeV] |
Rate [Hz] at 20 μA |
minutes for 100k events at 20 μA |
| 7.3 |
3.200 |
19.0 |
2.5 |
2455 |
15 |
110 |
| 7.3 |
2.019 |
19.0 |
1.6 |
3030 |
24 |
70 |
Alternative rates with 1-inch tungsten sieve slit:
* Assumes that 49 out of the 63 holes are seen (~ 0.52 mSr acceptance); however, the acceptance is reduced by 85%,
since not all foils will see all holes.
* Rates assume 5 carbon foils and 9% delta acceptance.
| Ebeam [GeV] |
P0 [GeV/c] |
θe [deg] |
Q2 [GeV2] |
W [GeV] |
Rate [Hz] at 20 μA |
minutes for 200k events at 20 μA |
| 7.3 |
3.056 |
19.0 |
2.4 |
2533 |
58 |
58 |
