Halls A and C Spectrometer Support Group Whiteboard

Priority Items

~~Jumper bars for SBB coils~~ Done.

~~Controls for SBB and corrector coils (software updates and re-test)~~ Done.

~~Install magnet leads for SBB (535 MCM cable)~~ Done.

~~Connect magnet leads for SBB corrector magnets~~ Done.

Readout for LCW pressure sensors added at end of beamline walkway (not started)

Re-install crash buttons in Hall A Counting Room - RQ1 button for BB and new ones for SBS supply and correctors (Done, SBS needs tested)

~~Install thermistors on SBS/Big Bite magnets and junction boxes.~~ Done.

~~Install Klixons on SBB.~~ Done.

Mount Left Shield House temperature readout in CH

Find video cables from hall in the CH

~~Measure current on 12V supplies in HMS magnet supplies when hall C is open long enough~~ Done.

~~Re-locate NDX detectors in Hall A - one in DAQ bunker and the other in BB GEM bunker~~ Done.

~~Test LQ2 FuG with new polarity reversal switch.~~ No longer needed.

Find and connect NMR cables in CH

Gas manifolds for GEM gas cylinders (started)

Nitrogen supply for GEM gas cylinder valves (Clippard valves and cylinder controller) (not started)

Gas mix controller and MFCs for GEM detectors (not started)

Roofing material for SBS GEM bunker (located some possible material - will run past Jessie)

Remove actuators from right arm magnets. (Dipole/Q3 complete)

clean up R-arm supply platform

clean up L-arm supply platform

Swap out MFCs in VDC mixing system

HMS/SHMS Heater and fan changes, fixes, upgrades etc.

Calibrate and op-check spare warm return valves for Hall C.

-2 wire cable, ferrules, \# 6 hardware

Replace air compressor in Hall A Gas Shed (on hold till next fiscal year)

Remote reset for Hall C spectrometer motion (maybe next year)

Install new liquid level meters on SHMS- Install done, waiting on software and LN2 probe cal to go live (need Steven).