Preparation

• Cable/HRS motion: add cable length and re-route the needed cables. Disconnect the others ?

• Left cerenkov overflow: move ADC from ROC 3 to ROC 4. Could we split the signal between the existing ADC in ROC 3 and the ADC in ROC 4 ?

• Deadtime:

               - remove the sequencer reading of BB and only read the main trigger module.
               - or set hight threshold on unused channels.

• Right arm Shower block 76 missing signal: check that it is at the bottom of the acceptance if cannot be fixed.

• Right arm S1: one channel is noisy.

• Right arm Cerenkov:

              - multi-peak in the TDCs: gate width problem ?
              - no obvious single photon electron peak in ADCs: increase HV.

• Right Q3: run Q3 at momentum ?% lower for each momentum setting.