How to start EDTM pulser (experts only)
From Hall A Wiki
1 Open a terminal from any computer in counting house and type the command:
->telnet hatsv4 2004
2 After connecting to that port and hitting the enter key, a prompt should pop up and we can set the EDTM pulser rate by the following command:
->r_pulser_Start(0,0xa100,0xc339)
The meaning of the arguments are explained below.
3 To quit from telnet, hold the ctrl key and hit "]". we should then see a prompt like "telnet>". Now type q to close the connection.
