November 13th 2020

• Updates
  • HCAL
    • cosmics working on right side - checking cabling - still DMA transfer error
    • prescale set to 0 to get all the trigger - was set to 1 so was taking half
    • could try to swap FADC from bottom to top crate
    • try with bus analyzer ?
    • Bryan will check readout list
  • Bigbite Shower
    • PMTs replaced , starting taking data yesterday - will take data over week-end - and switch to CODA3 maybe Tuesday
  • INFN GEM
    • running cosmics on week-end with CODA3 - running stable - replacing cable trays and will retest - no need to power cycle low voltage - 3 M events run
  • UVA GEM
    • replaced one MPD which was giving read out errors - need to look at data - no errors seen with new MPD
  • BigBite GEM
    • set of 5 APV for testing in TEDF, crates and modules installed
  • Hodoscope
    • Mark gave HV write up, can control HV
    • next set of 16 almost ready
    • will setup TDC after switch to CODA3
  • CDet
    • still debugging few individual channels
    • Update on Wednesday - might need to reboot after - update in mounting /site , update should be done through puppet
  • LHRS
    • getting started with intel CPUs and new TI for LHRS

• GEM DAQ rate limitiation : Ben working on simulation will

• RP VME rack and cable : need space for VXS crate and 1 HV crate and patch panel

• TI Daisy chaining mode for TI : need to test - need pull bundle of fiber TI

• Bigbite Calorimeter trigger :
  • would prefer to use digital as default
  • still keep analog trigger as back up and cross check
  • need develop WAPP trigger

• • analog trigger : need DAC setup for remote threshold control