November 20th 2020

• Updates
  • HCAL
    • haven't tried new firmware yet
    • data for silo
    • different shapes for a PMT ?
  • Hodoscope
    • one housing not well seated - unstacking and checking
    • 32 bars stacked
    • HV up and running, NINO supply hooked up
    • switch to CODA 3 and have independent session for data taking
  • INFN GEM
    • still check with Paolo for issue
    • backplane for UV chamber ? Paolo should help ? Need to check with Kondo and get start and finalize design
    • INFN UVA : still
    • BB GEM : all scripts installed CODA going - will test with APV
  • CDet
    • roped area around CDet - hot cryomodule in Test Lab - no impact so far on CDet - will
    • finishing up modules - trouble shooting module - PMT might be misaligned - will fix next week - take data for efficiency and crosstalk
    • cables : NINO - max length of 100 feet - 2 sets of cables - one to repeater and one from repeater to TDC - need to locate the cables Doug said he had them ( most likely BB VDC ribbon cables )
    • sbs2 computer reboots by itself - at 5:30 pm Wednesday - need to check if glitch - will look at logs
    • VETROC ordered
    • Kara can work on VETROC setup
    • can setup in clrlpc in new account for new session
  • Shower
    • took data
    • cables for FADC
    • can start with FADC for unconnected channels -
    • get HCAL code to look at FADC data
    • full waveform mode - for testing - production just time and amplitude

• Cables
  • HCAL cables 100 m ( right now half 50 m )

• • Location of repeaters for the NINO
  • need finalize low voltage for NINO location - not going - need longer LV cables -
  • in TEDF : 100 meters long cables - could use shorter cables