September 17th 2021
From Hall A Wiki
Revision as of 09:05, 17 September 2021 by Camsonne (Talk | contribs) (Created page with " *On going tasks **Cable to weldment ( Jack ? ) **cabling scaler/beamline crate ( David , Bob 0%) **HRS to TS and timing ( Bob, Maria 0% ) **EPICS / start End of run logging...")
- On going tasks
- Cable to weldment ( Jack ? )
- cabling scaler/beamline crate ( David , Bob 0%)
- HRS to TS and timing ( Bob, Maria 0% )
- EPICS / start End of run logging script (Alex, Bob 0% 09/15 )
- script check MPD sync ( Ben , Andrew ) - is new firmware ready ?
- RF (Alex, Bob ) - located RF prescaler and signal - need to send to HRS and SBS weldment
- sync check scripts ( Andrew , Alex )
- Hodoscope v1190 clock ( Alex , Mark , Ralph)
- check if calibration is needed after switch
- Full configration all crates ( Alex, Bryan )
- data rate test with new computer and 3 VTPs ( Alex, Bryan )
- test GEM zero supression ( Sean, Holly )- done
- GEM cosmics ( Sean, Holly )
- Shower cosmics (Arun, Provokar )
- HCAL cosmics (Scott)
- GRINCH cosmics ( Bradley )
- Hodoscope cosmics ( Ralph )
- DAQ documentation ( Alex, Rachel )
- suggest taking all detectors cosmics every night
- add scaler crate to full config
- coincidence trigger (done ? )
- EDTM (done ? )
- BB CAL and HCAL at TS - delayed after coincidence
- reference channel to all crates
- Final CODA config
- add FADCs for shower sum
- add FADCs for GRINCH and HODO
- timing hodoscope - V792 gate
- Issues
- network issue : one short fiber replaced, will try to put in protective tube
- LHRS
- GEM with TS hanging - need to check
- Shower FADC bad channel - FADC replaced but problem could not be reproduce - need to test more
- HCAL FADC bad channel
- HCAL ROC16 fiber - will double check if fiber 5 enabled - use slave5 - added additionnal fiber for ROC16
- warning PEB ROC - Bryan checking with Dave - might incorrect flag -
- Shower F1 issue at high rate - need to check with OT#2 - check at sync event implemented - DMA error might come from multiple pulsing - might
- Helicity scaler readout
- Status software in a-onl@aonl1
- GRINCH
- still need to install - need to check if commits were merged
- still running locally -
- Shower
- installed
- one script working with TS files
- GEM
- Andrew tried already
- Hodoscope
- installed
- HCAL
- setup and can look at data