May 25th 2022
From Hall A Wiki
Revision as of 09:37, 25 May 2022 by Camsonne (Talk | contribs) (Created page with "*Updates **HCAL ***will try to restart DAQ *** ***around 1 months ***VTP : readout list and configuration done, need to make a config with VTP readout ***need ***output from...")
- Updates
- HCAL
- will try to restart DAQ
- around 1 months
- VTP : readout list and configuration done, need to make a config with VTP readout
- need
- output from CAMAC have copy for VETROC
- Shower
- look into cosmics this week
- cosmics run for hodoscope
- hodoscope
- Glasgow will come for the summer
- RF going in left side TDC
- GEM
- move to Hall A end of next week
- fibers routing to SBS bunker - will route with other Bigbite cable around pivot
- Helicity
- setting parity DAQ for charge feedback
- SBS data streams - 3 streams will be put back together - seed calculated in crate and reported at every event - helicity bits are in FADCs
- prompt helicity - maybe not have charge asymmetry if one stream lost
- HCAL
- Beamline
- circular raster installed : checking uniformity, amplitude modulation giving a spike right now
- Update 3 stream readout : on going
- will send run number to Ole
- Tasks for GEn run
- GEM
- install fiber and network SBS
- add 2 VTPs to readout
- cable detector
- He3 target
- EPICS ?
- Helicity : prompt helicity ? - summer only Hall B cares - most likely should be ok - will need to check for fall
- HCAL
- VTP readout FADC
- VETROC copy TDC
- HCAL FADC trigger
- Shower
- VTP readout
- Shower trigger
- Trigger
- tested during GMn
- ready to go
- diagram timing - and check timing
- DAQ crashing more often with more APV
- if run starts and APV is failed during configuration - will be automatically disabled -
- GEM
and email send to mailing
- stand alone tools given to people for diagnosing issues - GEM related issue - connection on fiber transceiver - tools to diagnose quickly - FS transceiver have reliability issues - similar issue in Hall B - switch to Finisar - all hardware in EEL was debugged
- DHCP update : will try to move to main server using Jnet