Difference between revisions of "Compton"

From Hall A Wiki
Jump to: navigation, search
(Standard Compton)
Line 9: Line 9:
  
 
==Standard Compton==
 
==Standard Compton==
 +
 +
Monitoring the beam polarization using the Compton polarimeter requires two steps:
 +
 +
    * Take Compton data. These can be long runs, but since you can only check the polarization after a run has ended, it is best to start a new run every hour or two. When you end a run, click "Submit" to dismiss the gray pop-up window.
 +
 +
    * After a Compton run has analyzed (this takes about 10% the length of the run), check the logbook [1] for the Compton asymmetry.
 +
 +
If runcontrol shows that it can't communicate with a ROC or if the data won't analyze, stop the current run and type "coda reboot" into a compton@compton terminal window to reboot the ROCs and CODA. If the problem is with ER1, you will need to type
 +
 +
[code]coda_er -n ER1[/code]
 +
 +
into a separate window.
  
 
===Presentation===
 
===Presentation===
 
===Operation===
 
===Operation===
 
  
 
==Compton Upgrade==
 
==Compton Upgrade==

Revision as of 19:11, 7 February 2009

The Compton polarimeter can be used to non-invasively monitor the beam polarization. It has three major components: an optics table with a laser that can lock to a Fabry-Perot cavity; an electron detector to count scattered electrons; and a photon detector to count scattered photons. At present, the electron detector is in commissioning, so only the photon detector is fully functional.

Hall A Compton polarimeter Wiki page

Hall A compton webpage


Standard Compton

Monitoring the beam polarization using the Compton polarimeter requires two steps:

   * Take Compton data. These can be long runs, but since you can only check the polarization after a run has ended, it is best to start a new run every hour or two. When you end a run, click "Submit" to dismiss the gray pop-up window. 
   * After a Compton run has analyzed (this takes about 10% the length of the run), check the logbook [1] for the Compton asymmetry. 

If runcontrol shows that it can't communicate with a ROC or if the data won't analyze, stop the current run and type "coda reboot" into a compton@compton terminal window to reboot the ROCs and CODA. If the problem is with ER1, you will need to type

[code]coda_er -n ER1[/code]

into a separate window.

Presentation

Operation

Compton Upgrade

Photon detector

The new photon detector crystal is a cylinder of GSO with a diameter of 6 cm and a length of 15 cm. It was installed in Hall A in December 2008.

In October 2008, the crystal was tested at incident photon energies of 20 MeV, 22 MeV, 25 MeV, 30 MeV, and 40 MeV. We are working on extracting the response function.

PREx requires an integrating DAQ system, which will run on a Struck FADC. We are currently commissioning this DAQ with a prototype FADC.

Electron detector

Webcams address

Webcams were added to monitor the :



APC : hareboot4

*plug 2 webcam
*plug 3 EPICS Edet
*plug 4 trigger
*plug 7 FADC crate

Compton Edet DAQ