December 14th 2022
From Hall A Wiki
Revision as of 10:28, 14 December 2022 by Camsonne (Talk | contribs) (Created page with "*Updates **Beamline, helicity ***charge asymmetry, systematic large asymmetry during ramp (looking at helicit bits helicity : 50 k 14 part when beam ramp per while usually 3 p...")
- Updates
- Beamline, helicity
- charge asymmetry, systematic large asymmetry during ramp (looking at helicit bits helicity : 50 k 14 part when beam ramp per while usually 3 part per thousands ), most likely want to cut beam trips, can go back to this 50 k replay might still be flucuations
- BCM at low current for Moller, x10 with negative pedestal, switching to unew and dnew, 0.5 to 1 uA
- HCAL
- DAQ ok
- HV voltage issue
- TOF information needed ? RF ?
- GEMs
- BB running fine
- SBS off for 5 days, will put on Nitrogen, will try next year
- issue with stand alone SBS , INFN APV still cannot initialize with beam on, possible effect of SBS magnet ?
- Beamline, helicity
- GEM reset speed up ideas
- procedure
- improve the scripts to reset
- 15 minutes recovery typical
- print out of instructions of reset in counting house and point to RC
- simple focus instructions
- configuration of APV in parallel
- GUI of APV status
- coda message help with APV reset, pop
- MPD corrupted ? try reload firmware instead of power cycling
- procedure
