Difference between revisions of "HV Control GUI"

From Hall A Wiki
Jump to: navigation, search
m (Updated description of HV GUI table and desired voltage. -LT)
(changed adaq computer name to remove the "l" as they are now adaq1,adaq2)
Line 2: Line 2:
  
  
# Log on to ''adev@adaql1'' or ''adev@adaql2''.
+
# Log on to ''adev@adaq1'' or ''adev@adaq2''.
 
# ''cd slowc''
 
# ''cd slowc''
 
# ''./hvs BEAMLINE''
 
# ''./hvs BEAMLINE''

Revision as of 19:05, 29 November 2016

This GUI is used to enable/set particular voltage channels remotely.


  1. Log on to adev@adaq1 or adev@adaq2.
  2. cd slowc
  3. ./hvs BEAMLINE


This will start the GUI. Available channels should say "S1, S5, S6, S9, S12". Navigate to the table and select a channel. Make sure you know the desired voltage before proceeding. Check the box to enable, then click the HV On/Off on the left, if it is not already active.

Currently, we are working only with Slot 12, Channel 11, set to about -1690V. (desired voltage as of 2016-11-10)


Return to Compton