Difference between revisions of "HV Control GUI"

From Hall A Wiki
Jump to: navigation, search
m (Updated description of HV GUI table and desired voltage. -LT)
Line 7: Line 7:
  
  
This will start the GUI. Navigate to the table and select a channel. ''Make sure you know the desired voltage before proceeding.'' Check the box to enable, then click the HV On/Off on the left, if it is not already active.
+
This will start the GUI. Available channels should say "S1, S5, S6, S9, S12". Navigate to the table and select a channel. ''Make sure you know the desired voltage before proceeding.'' Check the box to enable, then click the HV On/Off on the left, if it is not already active.
  
Currently, we are working only with '''Slot 12, Channel 11, set to about -1600V'''.
+
Currently, we are working only with '''Slot 12, Channel 11, set to about -1690V'''. (desired voltage as of 2016-11-10)
  
  
 
Return to [[Compton]]
 
Return to [[Compton]]

Revision as of 10:18, 10 November 2016

This GUI is used to enable/set particular voltage channels remotely.


  1. Log on to adev@adaql1 or adev@adaql2.
  2. cd slowc
  3. ./hvs BEAMLINE


This will start the GUI. Available channels should say "S1, S5, S6, S9, S12". Navigate to the table and select a channel. Make sure you know the desired voltage before proceeding. Check the box to enable, then click the HV On/Off on the left, if it is not already active.

Currently, we are working only with Slot 12, Channel 11, set to about -1690V. (desired voltage as of 2016-11-10)


Return to Compton