HV Control GUI

From Hall A Wiki
Revision as of 16:13, 12 February 2016 by Lthorne (Talk | contribs)

Jump to: navigation, search

This GUI is used to enable/set particular voltage channels remotely.

  1. Log on to adev@adaql1 or adev@adaql2.
  2. cd slowc
  3. ./hvs BEAMLINE

This will start the GUI. Navigate to the table and select a channel. Make sure you know the desired voltage before proceeding. Check the box to enable, then click the HV On/Off on the left, if it is not already active.

Currently, we are working only with Slot 12, Channel 11, set to about -1600V"'.

Return to Compton