HV Control GUI

From Hall A Wiki
Revision as of 09:47, 12 February 2016 by Lthorne (Talk | contribs) (Added content to new page)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This GUI is used to enable/set particular voltage channels remotely.

  1. Log on to 'adev@adaql1' or 'adev@adaql2'.
  2. 'cd slowc'
  3. './hvs BEAMLINE'

This will start the GUI. Navigate to the table and select a channel. Make sure you know the desired voltage before proceeding. Check the box to enable, then click the HV On/Off on the left, if it is not already active.