HV Control GUI

From Hall A Wiki
Revision as of 10:18, 10 November 2016 by Lthorne (Talk | contribs) (Updated description of HV GUI table and desired voltage. -LT)

Jump to: navigation, search

This GUI is used to enable/set particular voltage channels remotely.


  1. Log on to adev@adaql1 or adev@adaql2.
  2. cd slowc
  3. ./hvs BEAMLINE


This will start the GUI. Available channels should say "S1, S5, S6, S9, S12". Navigate to the table and select a channel. Make sure you know the desired voltage before proceeding. Check the box to enable, then click the HV On/Off on the left, if it is not already active.

Currently, we are working only with Slot 12, Channel 11, set to about -1690V. (desired voltage as of 2016-11-10)


Return to Compton