HV Control GUI
From Hall A Wiki
Revision as of 13:20, 23 January 2019 by Cornejo (Talk | contribs) (Updated instructions for GSO detector)
This GUI is used to enable/set particular voltage channels remotely.
- Log on to aslow@adaqsc
- cd slowc
- ./hvs BEAMLINE
This will start the GUI. Available channels should say "S1, S5, S6, S9, S12". Navigate to the table and select a channel. Make sure you know the desired voltage before proceeding. Check the box to enable, then click the HV On/Off on the left, if it is not already active.
These Photon Detector channels are for PREX/CREX running conditions:
| Slot | Channel | HV | |
|---|---|---|---|
| GSO (PhDetector) | SL-12 | CH-11 | -1700 V |
| Side Finger | SL-6 | CH-10 | -xxxx V |
| Top Finger | SL-6 | CH-11 | -xxxx V |
Return to Compton
OLD INSTRUCTIONS
- Log on to adev@adaq1 or adev@adaq2.
- cd slowc
- ./hvs BEAMLINE
Old channel for PbWO4: Slot 12, Channel 11, set to about -1690V. (desired voltage as of 2016-11-10 to 2016-12-31)
Return to Compton
