HV HowTo for Users

From Hall A Wiki
Revision as of 08:57, 24 October 2017 by Jbane (Talk | contribs)

Jump to: navigation, search

High Voltage Instructions -- the basics

The High Voltage is controlled by LeCroy 1458 crates and associated modules like the 1461N. A trailing "N" means negative, and a "P" means positive HV.

Simplified Instructions : To control the HV in Hall A, do the following

Login as "aslow" on the "adaqsc" computers.

cd ~aslow/slowc

To run the Left HRS alone: ./hvs LEFT

To run the Right HRS alone: ./hvs RIGHT

To run the beamline crate: ./hvs BEAMLINE

Links to more HV help

These two links provide some old but useful information.



For experts


TroubleShooting for Users

After installing the rpi boards as servers, it seems that less goes wrong. If you have a setup that doesn't use rpi, you should upgrade.

1. Restarting the server sometimes is necssary. See the expert page https://hallaweb.jlab.org/wiki/index.php/HV_HowTo_for_Experts

2. Is the HV crate on ? There are two power supplies which must be turned on. Turning "on" in software will only turn on the HV if the hardware switches are in the right state and the electrical cables are plugged in.

3. If multiple cards seem "bad", I've found that power-cycling the HV crate helps. And what I mean by power-cycling is you go to the crate and manually turn it off (cutting power), then on. NOT just via the GUI but actually the hardware.

4. Need the sign ! Most of our cards are negative HV, and when you enter the target HV, you must also enter a minus sign. Like "-852" and not just "852". Beware !

5. Make sure that HV cards are all well-seated in the sockets, and no stress on the cables that can unseat the cards. Also, it has been observed before that a "bad" card can cause inexplicable problems. Finding and and replacing the bad card solves this.