Difference between revisions of "Halls A and C Spectrometer Support Group Whiteboard"

Latest revision as of 18:37, 25 April 2023

SBS air compressor maintenance

Hall C air compressor maintenance

Oscillator for LN2 level meter

Install pressure sensor in warm return in ESR for Hall C

Replace/repair dead MAGNET ON signs in Hall C

BigBite Argon manifold pressure sensor erratic. Need to clean the connections?

Some of the SBS magnet bus bars have been running hot. Do we need to re-torque them?

Readout for LCW pressure sensors added at end of beamline walkway (not started)

Add "T's" and pump out ports to HMS magnet vacuum gauge ports.-Steve didn't want work done.

Remove actuators from right arm magnets. (Dipole/Q3 complete)

clean up R-arm supply platform

clean up L-arm supply platform

Build new controller for testing and calibration warm return valves for Hall C

Build local valve control boxes with local read out.

op check/repair hall C vacuum gauges.

Re-route the Danfysik extension cables inside the HMS hut - get the excess off the floor

Cut and install poly shielding around HVAC controls on the Right HRS

Remote reset for Hall C spectrometer motion (maybe next year)

@@ Line 1: / Line 1: @@
-Heaters for HMS magnet flags
+== Priority Items ==
-Re-tap the SBS supply main transformer for full power
+SBS air compressor maintenance
-re-install ground fault detector in LQ1 supply - requires configuration of module
+Hall C air compressor maintenance
-re-locate displays for hacweb11 and 14
+Oscillator for LN2 level meter
+Install pressure sensor in warm return in ESR for Hall C
+Replace/repair dead MAGNET ON signs in Hall C
+BigBite Argon manifold pressure sensor erratic. Need to clean the connections?
+Some of the SBS magnet bus bars have been running hot. Do we need to re-torque them?
+Readout for LCW pressure sensors added at end of beamline walkway (not started)
+Add "T's" and pump out ports to HMS magnet vacuum gauge ports.-Steve didn't want work done.
+== Would Be Good To Do Items ==
+Remove actuators from right arm magnets. (Dipole/Q3 complete)
+clean up R-arm supply platform
+clean up L-arm supply platform
+Build new controller for testing and calibration warm return valves for Hall C
+Build local valve control boxes with local read out.
+op check/repair hall C vacuum gauges.
+Re-route the Danfysik extension cables inside the HMS hut - get the excess off the floor
+Cut and install poly shielding around HVAC controls on the Right HRS
+== Do We Still Need To Do These? ==
+== Possible Future Items ==
+Remote reset for Hall C spectrometer motion (maybe next year)