Difference between revisions of "Halls A and C Spectrometer Support Group Whiteboard"

Revision as of 13:42, 13 July 2021

Re-install crash buttons and Gas Master in Hall A Counting Room

Swap out MFCs in VDC mixing system

Remove three Oxford power supplies from HMS

HMS Q2 lead voltage drops

Heaters for SHMS magnet flags.

Hall A cooldown.

Heaters for HMS magnet flags-Heaters-modifications to guards complete, heaters installed. Waiting on controller.

Help Brad re-configure the DAQ rack in Counting Room C - May 17-21

Controls for SBS corrector coils

Re-tap the SBS supply main transformer for full power

re-install ground fault detector in LQ1 supply - requires configuration of module

connect power and LCW to BB supply on R-arm platform

Replace air compressor in Hall A Gas Shed

re-locate displays for hacweb11 and 14

clean up R-arm supply platform

clean up L-arm supply platform

Install new liquid level meters on SHMS- Install done, waiting on software and LN2 probe cal to go live.

Remove actuators from right arm magnets. (Dipole complete)

HMS supply control boxes into the Shield Hut

Gas mix controller for GEM detectors

Fix relay box for HMS counting room E-Stops

@@ Line 7: / Line 7: @@
 HMS Q2 lead voltage drops
-Heaters for SHMS magnet flags
+Heaters for SHMS magnet flags.
-Heaters for HMS magnet flags
+Hall A cooldown.
+Heaters for HMS magnet flags-Heaters-modifications to guards complete, heaters installed.  Waiting on controller.
 Help Brad re-configure the DAQ rack in Counting Room C - May 17-21
@@ Line 31: / Line 33: @@
 Install new liquid level meters on SHMS- Install done, waiting on software and LN2 probe cal to go live.
-Remove actuators from right arm magnets
+Remove actuators from right arm magnets. (Dipole complete)
 HMS supply control boxes into the Shield Hut